Thank you. I was going to try to put the down supports on the truss before lifting, but I wasn't sure the boom would handle the added weight of the truss with four supports in place, plus, I would have to line them all up on the cross bar at the bottom, so I'll be cutting and reinforcing each end and one center truss with 4 stiffeners before putting on the purlins and then the R panel.
I'm using 30' continuous section C purlins, and will modify the boom so I can feed them in from each side, up to the truss roof-line, and weld in place from below. I'm getting my MIG unit up there to do the purlins as they are lighter weight, and upside down welding with MIG is easier than stick.
Here's another pic of me up on the ladder welding in the angle truss support. Of course, it will all be much stiffer once the purlins and R-panel is up and screwed on. Then, I'm thinking of T1-11 eight foot walls with a wainscoat, and some kind of faux brick along the bottom to the ground. Stained red cedar, and I'm thinking of copper or burgundy R-panel roof sections.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Lifetime of David Brown - by Samuel Kennedy. I was born in 1950 and reared on my family�s 100 acre farm. It was a fairly typical Northern Ireland farm where the main enterprise was dairying but some pigs, poultry and sheep were also kept. Potatoes were grown for sale and oats were grown to be used for cattle and horse feeding. Up to about 1958 the dairy cows were fed hay with some turnips and after that grass silage was the main winter feed. That same year was the last in which flax was grown on the farm. Flax provided the fibre which w
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
