Posted by fixerupper on August 10, 2018 at 18:27:27 from (108.161.63.136):
Generator off a 630 Deere pos ground quit charging. It's a rebuilt from Deere I put on maybe 7 years ago or more. It will motor but it will not charge with the field grounded. I ran a ground jumper from the regulator frame to a good ground on the tractor frame and I ran a ground from the genny frame to good tractor frame ground but that didn't change anything. I pulled off the end cap and this is what I saw. It's not very clear, the top bar on the commutator has a burned spot in the middle. The brushes have not been making good contact across the commutator. All in all there is not a lot of wear but it looks to me like the rebuild job was done pretty fast and incomplete. Is this genny junk or is there some salvation in it? I could turn the commutator in a lathe to true it up but I don't think that will help me out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
