Posted by bjb in Tx from Ne on August 06, 2018 at 13:05:00 from (147.1.235.112):
In Reply to: Driving? posted by sald on August 06, 2018 at 12:33:32:
1. Drive it in what ever gear gets you the power you need a the speed you want/can go. You can throttle down as long as you don't lug the engine. If you are wide open you can probably be in a higher gear with less throttle. If your engine is lugging, then you need more throttle or a lower gear. Your highest gear is the "road" gear and wide open is the top speed. Also, the slower the engine the better economy you will get, so going in 4th gear at 1/4 throttle will use less gas than 1st gear wide open.
2. Your gear is down hill is related to the load and the safe operating speed. First gear with no throttle will give you the most engine breaking. If you need more then the brakes need to be well adjusted
3. See part 1. If you are lugging the engine at full throttle, you are in too high of a gear going up hill. The actual gear on the hill will again depend on your load and the steepness of the hill.
A few other points: A good engine will have more power and be able to use a higher gear Some trial and error with your particular machine will be needed to figure out the ideal settings A copy of the original owner/operator manual will also give you some data on safe operating ranges.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
