I ran snow plow for 15 years or so, one day during a nasty snow storm I was heading back tot he hyard for another load of sand,, a CAT parts delivery truck that makes runs every day to the local coal mines turned off the main hwy in front of me, I seen something come off the bed and hit the road and went Sliding about 80 feet down the road and came to a stop,, I stopped and looked to see what it was it was a 10' long 1" x 8" cutting edge,, think it was for a 988 loader but forget for sure now,, my partner who drove truck on the same route helped me get it on my snow plow and then I used it to lift it high enough we could slide it in my buddy truck box,, these were twin screw KW's were running and getting that 300lb plus chunk of slick Cold iron loaded on a major hwy was no fun,, we took it to the Cat dealer and they hardly said thank you even,, I was like gee we busted our butts to get it back and save the State plow trucks from hitting it and thats all you can say? he did offer us each a cat hat,,, like we did not have boxes full of them already lol cnt
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
