Posted by Bob on August 04, 2018 at 14:04:14 from (64.255.159.199):
In Reply to: 4020 brakes sticking posted by Kory1998 on August 03, 2018 at 19:14:07:
Quoting Removed, click Modern View to see
Kory, simply loosen locknuts on brake bleed screws, then loosen bleed screws two turns.
This "dumps" brake pressure "to sump" internally.
Note whether or not the tractor acts different/the brakes release.
When done, snug down the brake bleed screws with the locknuts loose enough so the screw can bottom before the nuts get tight, then, when the screws are tight, snug down the nuts.
If you should accidentally unscrew the bleed screws too far, note that there is a steel ball in the port, that the bleed screw clamps down on.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Crank Start a Tractor - by Staff. This interestin discussion is from the Tractor Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
