Posted by Destroked 450 on July 16, 2018 at 08:08:43 from (173.242.142.14):
In Reply to: cost to make hay posted by cjunrau on July 15, 2018 at 07:09:58:
I'm a small guy and don't rent much hay ground, on the ones I do tend if it's simply cut and bale without investing my money into the land I'll do that on a word of mouth or hand shake agreement.
If I have to clean up any of the land, apply seed, lime, or fertilizer it's a 5 year written agreement or I'm out.
I'm not going to invest time and money building up someone else's land just for them to rent it to another person next year.
My tractors are 40-72 hp diesels so fuel consumption isn't bad.
My 52 hp tractor burns around 1/2 gallon per acre pulling a 9 ft disc mower, cuts 4-5 acres per hour depending on how rough the field is.
Tedding and raking both equals around the same 1/2 gallon per, 72 hp tractor with baler making 4x5 bales burns around 1 gallon per acre. I bale around 4.5- 5.5 mph, hays fairly thick and I like to feed it at a slower pace, tractor starts running out of power if I go much faster.
Most of our hay is fescue, orchard grass, clover mix, on poor ground we'll make 2 1/2- 3 bales per acre, average ground 4-5 bales per. I apply chicken litter to my farm keeping the nutrients in the upper scale on soil test charts, that ground will make 6-8 bales per acre on average years.
Baled a 5 acre field last week, late 1st cutting with lots of growth, 42 4x5 rolls from 5 acres = 8.4 bales per acre.
This year with cold wet spring weather early 1st cuttings only averaged 3-4 bales per acre on good ground.
Later 1st cuttings had lower quality but made more bales.
One field made more bales on the 2nd cutting than on 1st cutting, 1st time I've ever had that happen.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Uncle Cecil's Super A Lives Again - by Mike Purcell. A week or so out of most of my childhood summers was often spent with my Uncle Cecil and Aunt Sissie in the small East Texas town of Maydelle on their 80 acre farm. Some of my fondest memories of these visits are those of learning to drive a tractor at the helm of Uncle Cecil�s 1948 Farmall Super A. Uncle Cecil was the second owner of this wonderful little tractor, but it was almost as though he had adopted an infant. The original owner was a man from Minnesota who bought her from a local dea
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
