The A for heavier tillage for sure and no comparison on that. That said, the hand clutch and fast reverse do not make it very nimble tractor IMOP.
The Farmall Super C if you want to use it more like a little nimble utility tractor for things like mowing and back blading etc.
I have a late JD A (1950) as well as a 1951 Farmall h and a 1946 Farmall M. Both of my farmalls are far more nimble than the JD A. I love the JD A for raking hay and I bet it would have been a favorite for cultivating row crops back when that was still done before herbicides took over. The John Deere A is a fine tractor when used out in wide open space where you put in a gear engage the clutch and go. Lights of tight quarters, frequent direction changes from forward to reverse or frequent speed changes then not so handy and I will pick either of my Farmall's for that work myself.
4 cyl engines are smoother on PTO work too. Gutsy Super C have been known to outwork Farmall h's at times. I think I would go Super C and plan on 6' disc.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.