Posted by jeffcat on July 10, 2018 at 13:32:40 from (76.116.234.200):
In Reply to: Re: Willl this work posted by NY 986 on July 10, 2018 at 12:50:35:
I agree with you. One inch is no big deal. Only thing I would advise is make sure you have plenty of air flow or be just a little easy on how much you feed it. Remember...with that reduction at the bottom to a larger pipe, when it plugs up there will be an almost impossible amount of PLUG. Small to bigger is fine, bigger to smaller trying to unplug it is like a check valve. If this is silage you are blowing, take a garden hose and turn it on full tilt. Tywrap it over top of where the table dumps into the blower. That little bit of water makes things more slick. When it was very dry weather making silage the water trick worked wonders. One little tip. At the bottom of the larger pipe you can cut a hand hole door. About 5x5 is just big enough. Make it out of a piece of stove pipe the same diameter. The curve will match up to the blower pipe. Use one of thoses flip latches to lock saftey catches. Like you use on a shed door. Makes it pretty easy to unplug things. FIRST SHUT OFF THE BLOWER. Just unlock the latch, remove that acces pannel, and you can get at the plug.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
