Steve ...... interesting comment about the crown up .... if it appears noticeably up when you decide which side is up. If not apparent, the annual rings curve is usually the way to tell for flat boards, ie annual rings crown up (according to some references I have read). But either way doesn't always end up being the end result you want ...... sometimes it works out and other times not. I've had unwanted cupping after putting the crown up and also the annual rings up. For whatever reason, it's a good rule of thumb but not bulletproof in my experience. The warping you mention is for sure an issue, shrinkage I find will happen regardless. Starting with the boards at say 1/8" spacing will end up with 1/4" space or sometimes even more.
My friend has built hundreds of house decks as a business. Once he decides which side is "up", he often cuts a saw kerf (slot) lengthwise on a table saw about 1/2 the thickness of the board (so say 3/4" deep on 1 1/2" lumber decking). His kerf is centered on the board and then he installs saw kerf down. Not necessary on 2x4 decks but he does it on 2x6 jobs. Once he nails or screws those deck boards down, they stay flat and have a tendency to stay flat and not cup. On a trailer deck, I suspect mud and moisture being flung up from underneath might be a bit of an issue with a saw kerf.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Product Review - by Staff. When we finally checked out the 3000 PSI North Star, the whole story chaned. This unit was equipped with an 11 HP Honda engine with fuel shutoff, adjustable flow and optional syphon degreaser dispenser. It didn't have a pressure release or electric start to facilitate easy starting but according to the instructions, simply pulling on the trigger while cranking was sufficient. This method of starting proved more than adequate and kept the cost down on the unit. It had all the important
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
