Posted by keith true on July 02, 2018 at 12:06:58 from (174.63.60.234):
In Reply to: Re: Trailer axle posted by tomturkey on July 02, 2018 at 11:30:52:
Two 10,000 pound axles would give you a 20,000 pound capacity.A pair of six's would give you 12,000.I happen to like more lug nuts,six is OK but eight is better.I just ran into an interesting axle situation.I'm replacing a pair of 7000 pound axles,the owner has a unique application where the axles have to be widened out just a little.I installed the new ones,and bought his old ones for myself.His trailer was built in Texas and has the spec sheet with it.It states 7000 pound axles.When I sliced them in two to skinny them up for myself,I found one was made with thick metal and one with thin.The Dexter tags are for 7000 pound axles,so I won't say the trailer manufacturer was cutting a corner,I just think somebody dropped the ball when the axles were made.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
