Posted by legacyacressteve on June 13, 2018 at 11:58:46 from (45.46.80.42):
I am so stuck on this problem, and I am hoping one of you can help. I have a 2240 that is consistently overheating. My first suspiciion was the thermostat, so I replaced it with a brand new one from the JD Dealer. It didn't fix it however, and the radiator remains cold... The fluid from the engine is of course hot, but it seems the thermostat never opens as there is no flow through the top of the radiator. So I decided maybe it was the water pump. So I pulled everything apart (the entire cooling system including the radiator). Cleaned everything and flushed everything. The water pump was in perfect working order. So I reassembled the system, (including the thermostat) same problem. Radiator cold, engine hot. I removed thermostat, and sure enough problem was fixed (that made me consider maybe the new thermostat was bad). I put the new thermostat in boiling water, and it opened right up.
So I am lost.. water pump works.. thermostat appears to work,radiator is clean and not blocked but the flow from the thermostat never occurs when the thermostat is in.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
