Posted by Chris NW Ind on May 16, 2018 at 11:05:24 from (174.221.138.49):
In Reply to: Re: Chain Saw Gas posted by Two0aks on May 16, 2018 at 10:23:44:
This is just silly.
As another poster pointed out, we have much better oils available today. Your tiller says straight 30W mixed 16 to 1 because that is what was available in 1950. Now we have semi-synthetic and full synthetic oils, all light years better than 30W.
I have seen tons of old 30W using saws with carboned up ports from that dino oil. Don't see that with synthetic. My opinion is modern saws are more likely to burn up from the much higher RPMs they run over the vintage stuff. 9K rpm vs 13K. That and poor air filtration.
For myself, I use 32 to 1 synthetic in everything 2 stroke, from my 2 man Disstons and Homelite muscle saws to my modern high winding Husky 357.
If you wonder about my qualifications, I own around 250 saws and have been through most of them.
And, to clarify, my only point is simply to say that old oil mix specs are just that, old and obsolete. Would you insist that the 30W oil you use also be 60 years old?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
