Posted by Grandpa's Fords on May 15, 2018 at 06:59:21 from (50.32.137.94):
In Reply to: Cold showers posted by 550Doug on May 14, 2018 at 14:34:34:
Quoting Removed, click Modern View to see
I share your trepidation, upon reading about the gravity systems I had the same concerns and didn't quite buy into it. I believe you are correct but can't prove it.
Fortunately for me I had a roll off 1/2 pex and several fittings left from a previous project. I installed drops from the hot side of each location tee'd to one line with a check valve and tee'd into the HW supply at the boiler. Water flow is constant no pump. Had to bleed everything to get it to go, But it did.
I did throttle the return back a little to induce more hot water out of the boiler. The only thing I didn't do as I mentioned before was to get it all insulated which I still need to do.
I'm not sure if I just got lucky and it worked or there was some sound principle behind it. None the less it work for me :D :D
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - On the Road with Dave Gohl: Auction Musings - by Dave Gohl. I was thinking the other day about all the auctions I've been to in the last few years. There've been many. Some have been very good, some have been well, disappointing to say the least. But no matter how good or bad auctions may be, we always seem to stay until the item we've come for or are interested in is on the block. I've been to some auctions near and far. I think the furthest has been the Two Cylinder 7 in the Amana Colonies last year. Lots of stuff, lots of people. I've also atten
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
