Everyone will have a different view on this, give some of the variables with processing firewood for ones home heating needs. No doubt, a 3 pt splitter running off tractor hydraulics that are marginal for using one of these gets old real quickly. Same is true with the older style "low rider" splitter,as the work height is very uncomfortable.
The horizontal-vertical splitters offered today by current manufacturers are a big improvement from those low rider types.
Personally, I like the Speeco log splitter line, TSC's Huskee brand re-badged. It's built with a full beam,(unlike many where the cylinder projects past the beam). Some are or were offered with a Honda engine, wedge is on the ram and when retracted with a jammed block of wood will clear the blockage. I thought the product line they make is a good value for what you spend for a homeowner grade splitter. What model, by what manufacturer is best for your needs will be your decision to make.
There are higher end manufacturers, custom builders and so on, these will cost you a lot more, but are also suited more for higher volume or production.
There are lots of peripheral tools and accessories you can add to your tools to make the work easier, Peavey - Timber jack, pulp hooks, pickeroons, log grippers etc. I use gardenway type carts for hauling the split wood to the stack, and blocks to the splitter. I try to work as little as possible off the ground and the 28 ton Huskee I've had since '12 works well for my needs.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
