Posted by nater9500 on April 24, 2018 at 16:59:48 from (107.242.117.1):
Hello I was wondering if there's someone who could help me figure this out I recently purchased a white 2 -105 and it has a newer hydraulic pump on it only problem is that where the steel line is supposes to go right in the middle of it there is no hole going into the pump for this line to go into so they just put a plug in the end of the line i was wondering if anyone knows what this line is for everything seems to work ok other then sometimes when you use the remotes or raise your three-point pump grinds like it's running out of fluid then it stops it comes and goes cold or hot was wondering if that line not being hooked up has something to do with it. I put a new pump on my 2-85 last year and it has the hole for the line to go into tho the pump on the 2-105 looks biger. any help would be greatly appreciated thanks
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.