Posted by Dan S (NY) on April 23, 2018 at 10:30:14 from (96.32.119.34):
I bought this 1931 Ford model A based doodlebug about six weeks ago. It has probably not been run in decades but at least was under a roof. Engine was stuck but after a week of soaking with an ATF/Acetone mix it would turn a little with a pry bar on the flywheel teeth, but not much. Ended up pulling the engine out. One cylinder had been lightly stuck, but most of the problem was the massive mouse next in the flywheel area gumming everything up, plus some starter bendix parts may have been jamming the flywheel. Cleaned all the gunk out of the engine and clutch, freed up a few sticky valves and put it all back together with a few new parts. This past weekend we were able to get it started for the first time. After some initial rough running, it smoothed out pretty good and didn�t make any bad noises! It still needs lots of work but at least it runs. The monster front tires have already been replaced with regular 30-31 style model A wheels which look a lot better.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
