Posted by rossow (mn) on April 21, 2018 at 08:21:45 from (216.114.227.193):
I'm having a hard time getting an estimate on a machine-shed floor. ("We'll get back to you in a week or so....") The shed is in southern Minnesota. It is only a few years old and in great shape. It is the typical pole frame with metal sides and roof and a crushed-rock floor. It measures 40x72.
My question: Assuming a level floor, how much should I expect to spend for a 40x26-foot x 6-inch slab in one end of the shed? I know additional rock fill and compacting would add to the cost, and it might require some wheel-barrowing to get the mud into the far corners. I don't mind an estimate that's off by even low thousands. I'm just wondering about the basics: rebar, mesh, concrete and labor. I know sight-unseen is hard to do, but I would be grateful for ANY educated guesses you might offer on a 40x26 with 6-inch reinforced concrete. (I can provide more info if needed.)
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Sunday Drives - by Cowboy. Summer was finally upon us here in Northern Maine. We have two types of industry up here, one being "Forestry" (Wood Products) and the other "Farming" (Potatoes). There is no shortage of farm tractors and equipment around here! I have been restoring old Farm Tractors for the past 6 years, and have found it easier and less expensive to hit all the auctions and purchase whole tractors for parts needed. My wife who works at a local school, and only has weekends and summers off, while on t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
