Posted by K Effective on April 13, 2018 at 06:03:41 from (162.235.236.141):
In Reply to: shop lights posted by 88-1175 on April 09, 2018 at 18:29:56:
We've been replacing the 200 four-bulb fluorescent tube fixtures at the parochial high school I attended. The device of choice is a retrofit unit- the troffer or metal box stays the same, but all the electrical inside is removed- wiring, ballasts, tombstones, all of it. The replacement LED unit has three strips molded together, and is held in place by two self-drilling screws. It then connects to the 120V hot and neutral, even provides those new orange plastic quick connect wire connectors, so any replacement should literally be plug-and-play. Once proficient, I can retrofit a unit in under ten minutes each. The only ones we replaced the troffer(metal box) were to install battery backup lighting at entry ways- with LED the whole fixture can be run on a battery, just not the retrofit units.
I have four, four-bulb fixtures in my shop area, and plan to retrofit them with this kit, but have yet to complete the school project, much less get to my own projects...
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Corn in Southern Wisconsin: The Early Years - by Pat Browning. In this area of Wisconsin, most crops are raised to support livestock production or dairy herds in various forms. Corn products were harvested for grain, and for ensilage (we always just called it 'silage'). Silo Filling Time On dairy farms back in the 30's and into the first half of the 40's, making of corn silage was done with horses pulling a corn binder producing tied bundles of fresh, sweet-smelling corn plants, nice green leaves with ear; the
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
