Posted by JD Seller on March 19, 2018 at 17:46:56 from (208.126.189.95):
In Reply to: John Deere 1010 posted by SodBuster87 on March 19, 2018 at 16:25:24:
The JD 1010 GAS was not a bad little tractor. They had an odd hydraulic pump setup but that did not cause much problems. The power steering was not great.The sleeve deck motor made overhauls harder and more expensive. They ran fine. The diesel motors where headaches and the JD 2010 was a much more complicated mess of a tractor. The gas models where kind of tolerable and the diesels a nightmare waiting to happen.
I owned a JD 1010 utility for close to 20 years. I never really had many problems with it. I bought it with a bad motor and overhauled it right then. So the motor was never an issue. I actually liked the independent PTO on it. The lever was easy to reach form the ground. So that tractor ran the grain auger and hay elevators 95% of the time. You could walk up to it and start it and operate the PTO from the ground.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - A Belt Pulley? Really Doing Something? - by Chris Pratt. Belt Pulleys! Most of us conjure up a picture of a massive thresher with a wide belt lazily arching to a tractor 35 feet away throwing a cloud of dust, straw and grain, and while nostalgic, not too practical a method of using our tractors. While this may have been the bread and butter of the belt work in the past (since this is what made the money on many farms), the smaller tasks may have been and still can be its real claim to fame. The thresher would bring in the harvest (and income) once a y
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
