So, I can haul grain from my field to the conventional elevator 3/4 mile from my driveway. They can store it for me, dry it for me, sell it when I need to sell it, deliver any grain I store on my farm any weekday I want and get a check 4 days later.
Or I can grow organic, and deliver it to the one buyer 23 miles away. When they want it. They will pay for it on their schedule. If they get full or their buyers change their mind, I am outa luck. My crop is sitting in my expensive bins, and on one within 100 miles wants them.
That premium looks real nice, but it has a -lot- of risk to it. If you are in a Mitch where the buyer is close and works well with you great. I'm all for it.
You know how much I would need to invest in crop drying, storeage, and transportation to go organic? How much risk in dealing with just one buyer?
Give it some though. I did a few years ago........
Organic costs a lot at the store. I don't understand what it offers to consumers, butt hat is their business. It doesn't offer much at all to the farmer, unless you are in a special nitche location or dirt or situation.
The actual direction this is all going is like General Mills. Screw the farmer don't need them. Control the land, hire a management firm from California, use technology to run the tractors and combines, hire very few people, no farmers, and vertically integrate.
If I had a nitche of organic that penciled out for me, I would do it. But I would understand the risk I was taking, and the overall short term the ride will last.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
