Posted by flembo on March 11, 2018 at 09:08:19 from (67.142.96.25):
In Reply to: todays photo posted by IanC on March 11, 2018 at 07:05:27:
What is pictured looks like Broad leaf Tobacco mostly used for cigars and outer wrappers, I grew up in Conn. And worked Tobacco at age 13 to 15. the Tobacco Farmers would come to the schools and set up tables in the halls you needed to be 13 yrs. old To get working papers. Shade grown tobacco was grown under nets where the temp. could reach 120 deg The big time Shade Grown Tobacco farmers would bring in Jamaicans to work under the nets. They picked the leaves and put them in baskets that were pulled to the outside then picked up and loaded on wagons and brought to the barns. The white kids worked in the barns. The girls sewed the leaf’s onto lathes then the boys hung the full lathes on racks called tiers. The higher up in the barn the pay went up a few cents the highest tier was called the pearl tier the older boys got the higher tiers the pearl tier had bragging rights. Broad leaf Tobacco was grown out in the open and the entire plant was chopped off at the ground and the entire plant was attached to a lathe and hung in the barns the same way. The barns were built with every other board hinged at the top so they could be propped open for air circulation. Large propane heaters speeded up the drying process. Usually around October the tobacco was shipped off to the cigarette and cigar manufactures. I am going back to the early to mid-60’s so I may not be 100% accurate on my description so don’t beat me up over details. LOL
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.