Posted by JD Seller on February 27, 2018 at 19:00:19 from (208.126.196.24):
In Reply to: Planter hydraulics posted by caterpillar guy on February 27, 2018 at 12:26:19:
Your correct in that pressure only effects lifting force butttt you need flow with pressure to lift. I have seen a lot of IH tractors lose pressure when you demand flow. The newer tractors operate at 2750 PSI and up the old 2250 PSI standard is not enough anymore. Also when I check older tractors very few of them are even at 2250 PSI anymore. Lots of 1500-1800 PSI when hot and with a flow demand.
The 66 series IH tractors had lots of things that were good about them but the hydraulics was not one of them. The double pump system was designed for operating a cylinder with 8-10 inches of stroke. Now put it on a planter that may need to fill 4-8 cylinders with a demand of 2500 PSI of so and they do not do well.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for �200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
