I have several carbide lamps, used mainly for coon and fox hunting. Most are the small ones that clip on your hat, but I also have a large one that hangs on your belt and has a big reflector on a headband. It has a hose from the belt to the reflector, and it makes a very nice light.
When I was a young man and enrolled in welding classes, the instructor's first lesson was about acetylene generators. He said that if on your first welding job you walk into the place and discover that they use an acetylene generator, turn right around and leave to look for a job at any other place. It was not a question of IF that thing would malfunction, it was a question of WHEN it would malfunction, and you did not want to be there when it happened. I've only seen two acetylene generators in use in my lifetime. One was owned by a very intelligent and cautious blacksmith/machinist, and it never malfunctioned to the point of destruction. The other one was also owned by a very intelligent and cautious blacksmith/machinist, and I was one block away when it blew all of the doors off and blew all of the windows out of his shop. It seemed like a miracle that he wasn't seriously injured. It burned all of his hair off that wasn't covered by his cap, and even left little white marks on his red face for each BB on the little chain between his welding goggles. It is a good memory because he survived, even though the shop did not. So - my view is that anyone who survived the use of an acetylene generator had the Lord looking out for him.
No - never saw it used in a home in this area (Southern Illinois). My brother had gas lighting in his big old house in Buffalo, New York, but I don't know if it was city gas or acetylene generator gas.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
