That is true about the new pipe but the working pressure from a air compressor is a fraction of the bursting pressure rated with a new pipe. Then when a pipe is broken there is not shrapnel flying all over the shop. I've have been within 10' of a pipe break on three occasions and all it did was make a lot of noise. The pipe could have been glued back together if there was an adhesive that would hold with all of the plastic there. It breaks like a pipe broken from freezing water. The pipes breaking is from them being poorly installed. The shops that I worked in would run a pipe down a column and put an elbow on it where they put a coupler. Then the pipe was attached to the column with duct tape or a zip tie. In my own shop I weld a steel plate to an steel elbow and attach that to the column and run PVC from there. I've never had a pipe break in my own shop and some of the pipe dates back to the mid 1980's and some of this pipe has been exposed to the Texas sun for more than a decade.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Gatherin of the Orange - by Rick Nikolich. In July of 1998 I was talking to fellow Allis Chalmers collector Mike Schilling about the annual "Gathering of The Orange" AC show coming up in August of 1999. He got this wild idea that we should get a convoy of AC tractors and drive them from Charlotte, Michigan 105 miles to LaGrange, Indiana.
... [Read Article]
Latest Ad:
one 8n and one 9n tractor. totaly restored,pretty much everything is new. one 6ft blade good shape.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
