Posted by fixerupper on January 27, 2018 at 19:24:48 from (100.42.94.143):
In Reply to: Hydraulic motor posted by HNM on January 27, 2018 at 14:54:13:
Buick is right. 540 is screaming. I converted my old Danuser to hydraulic drive using a hydraulic motor that drove the reel on an old Deere bean head. The tractor has a 16gpm pump but I highly doubt if the motor gets more than 10gpm. The auger is now on the front of the loader and runs at about half the speed it ran when it was PTO powered but now with the down pressure of the loader I can basically corkscrew the auger into the ground, shut it off and pull it out. I don’t know why I would want it to run faster. Power wise the motor is just adequate but not over powered. If the auger catches a rock it stops the auger before damage is done.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
