I can't turn stuff done either. The problem is there is. O where for the good stuff and the treasures end up in a pile which need to be moved out of the way to do something.
And then when I want to bring a tractor in to service, the 16' wide bay is down to 9'.
Anyway it's getting better. I have all the plumbing and irrigation fittings fairly well organized on the far end of the barn.... stuff we always use etc. But this is sorta the main shop area. The 12 steel work /welding table apparently has a top and is a nice area to work ... but I haven't seen it for 5 years, it's completely covered in odds and ends of metal, parts, belts motors. Better than on the floor I guess.... oh it's covered too.
I have no problem sending stuff to the scrap yard... but I want to make sure it's really junk. Every now and then dad gets in a crazy clean up mood. Last year I went out to the area where equipment goes to die and noticed the old Louisville flat deck was gone... I know it didn't drive away. I went in for coffee and asked what happened, he said he saw a sign for scrap removal and wanted to clear the area for more stuff.... anyway long story short I could have used at least 4 of the tires, the deck, wet kit and probably some of the other odds and ends.
So basically I'm just trying to go through everything before another purge takes place. Thanks for the ideas. Grant
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
