Posted by carvel minne farmer on January 20, 2018 at 09:26:51 from (207.228.78.41):
In Reply to: Tractor shed posted by Grandpa love on January 20, 2018 at 07:29:41:
Quoting Removed, click Modern View to see morning kevin, when you go to arlens be sure to bring the big trailer so you have room for the ford on the trip home :lol: I run into the same thing over and over kevin in my business repairing welders, I had one customer call and order over $3000.00 in chrome work for his welder (covers, doors, panels) and when it came in I called him and he brought his welder in, we installed all the new chrome pieces, fired up the welder and I heard a knocking sound!! shut it down and went looking, the water pump bearing was shot! advised the customer we need to change it out NOW. if that piles up it will send the fan, fan hub and shaft through the rad. I gave him a price of $150.00 to change the pump now or if he left it it could cost him up to $1200.00 or more. "OH NO HE SAID IT WILL BE FINE" been running like that for a long time :roll: 11 days later he was back for a new pump, rad, fan, fan belt, and 8 hours labour $1500.00 :lol: as my good friend tim told me "john there is no cure for stupid". and i'll bet money you'll be back there building a new tractor shed. all we can do kevin is give them our best advice, and I never argue with them, just bill them!! john.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
