Posted by RN on January 20, 2018 at 08:55:53 from (205.213.104.118):
In Reply to: Tractor shed posted by Grandpa love on January 20, 2018 at 07:29:41:
Any particular building permit laws in the area? Looks like a 8 x12 shed, 96 square feet and that means under 100 sq/ft limit in some places that requires building permits and inspections for larger structures. Had a couple little building projects where larger meant a bunch of paperwork, current concern for small homestead has 200 sq/ft or bigger needs building permit, under does not so last years shed project was about 8x14. If no legal restrictions- then another 4 foot wide front bay section could be put on next summer after wet tractor nose causes some concern. Maybe hang a tarp on front to half drape over front of tractors, plenty of blue floppy shed doors in many country neighborhoods. Looks like pole shed built to stock size 4x8 panel size walls, roof is the sheet metal standard 8 to 12 footers? Quick and cheap building plan used? Something like that in Wisconsin would be used for sheep, horse and calf shelter, open side to south or east, wind break with some straw on floor and come spring use composted floor diggings for garden - what I did on small sized shed used for ram shelter placed next to garden fence. Ram shelter was fixed up and reinforced (rams do play with hard horns against walls) with mostly stock sized lumber, metal and plastic panels small stock sized that would fit in back of pickup. RN
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
