I agree with a fair amount of the others. You have taken inventory of the situation and selling down looks to be the most logical choice. As the others have said maybe hang on to the land if practical because once gone it is gone. I was in a situation where I had to sell some ground a bunch of years ago and although I had no choice it eats at me today that I no longer have it. As far as the auction goes the auctioneer knows the best plan of attack for your area. Around here doing it during the week tends to be normal although this past December there were a handful of Saturday sales. If you are not pressed time wise maybe sell a couple pieces online and see how it goes. If it does well you could do the rest that way. You would most likely draw from a larger crowd that way. The snow bird down in Florida can watch and if he wins he can send somebody from home to finish up for him. I know in some ways you feel glum as though some sort of defeat has been forced upon you. Realize that this landlord situation is going to provide income and you don't have to go begging for a job like many who are forced out by the bank.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
