Posted by welding man on December 29, 2017 at 08:51:58 from (76.9.238.216):
Friend of mine called last night in a splutter saying his Kubota M 8540 had developed a strange engine oil leak while feeding round bales. It was dark when he called and he couldn't tell much about where it was coming from, but would call back this morning. Well he did. He went out where the tractor is parked in the shed and he found a plastic plug laying on the ground.He started the tractor and sure enough oil was coming out of the hole where the plug came from. No threads, just a straight hole in the block near the oil filter. I said I don't have a clue. So I get on the internet and did a little research and guess what, apparently this happens quiet often in really cold weather. Some called it a pin plug. Would some of the Kubota experts please explain what this hole if for and why a plastic plug with no threads. He called the local dealer and they said , Yes it happens from time to time but,no explanation as to why, or the fix for it, except, put the plug back and don't worry about it. Thanks in advance.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
