Posted by Tx Jim on December 29, 2017 at 03:26:28 from (166.137.143.110):
In Reply to: 2640 oil leak posted by oldcornfarmer on December 28, 2017 at 11:16:45:
I'll guess to utilize Boling Machine shop seals one must replace bushings @ $95 per set. I was taught when employed by a JD dealer as a service manager to only replace L/D bushings if worn enough to justify replacement. I've never had a problem with leakage when utilizing JD L/D seals on JD utility tractors if shaft was not worn too much & shaft side play was eliminated with shim washers.
I agree Bolings bushings/seals for 3010/4010/3020/4020 are far superior to JD seals but I've never seen 1st hand Bolings seals for a JD 20-55 series utility tractor L/D shaft
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Stories From Old Farmer - by K. Pratt. Old Farmer, a.k.a. Dale Jensen began posting messages to our discussion forums at the grand age of 75. With extensive knowledge of farming and tractors, he valued the past and the ways that went with it. He shared these values with us until shortly before his passing. I spoke with Dale in his last days and requested his permission to share some of his stories with the readers of our magazine. He agreed, and provided the
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
