Posted by Bob on December 25, 2017 at 18:43:57 from (64.255.159.199):
In Reply to: JD 4020 posted by wide axle on December 25, 2017 at 17:30:05:
That's a good question, I would have thought it threaded in with pipe thread, but it appears that the fitting is just pressed in, as it's not shown as a separate part. So, I suppose it's like the tubes, fittings, or hose barbs pressed into various waterpumps.
Over $200 for a new cap and elbow!
At this point, I'd clean it up and see how tight it fits.
With it removed from the oil cooler, clean it with solvent, and clean and rough up the fitting and hole with a wire brush, sandpaper or sandblast it, then stick elbow back in place with Loctite Sleeve Retaining Compound (IF it's a pretty tight fit) or a good quality epoxy, if it fits a bit loose, and allow to cure, then clean the assembly THOROUGHLY before reinstalling to make sure no abrasive or other debris gets in the cooling system.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Step by Step 12-Volt Conversion - by Bob Melville. Below are step by step instructions to convert a 6 volt Farmall M or Super M with battery (not magneto) ignition to a 12 volt alternator electrical system.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
