Posted by Switchflicker on December 19, 2017 at 07:12:13 from (142.160.42.77):
In Reply to: Backing a Trailer posted by Traditional Farmer on December 19, 2017 at 04:54:44:
Boat Ramps
After screwing around for an ungodly amount of time and finally getting lined up with the ramp. Trailer is now nice and close to the water, they stop and get the boat ready for the day's fun. Remove the tarp and straps. Load the skis and coolers. Clean out the garbage can and expired beer cans. Clean the windshield. Back the boat into the water. Pull the boat out of the water. Install the drain plug. Back the boat into the water. Leave the boat beached on the ramp. Park the truck and trailer. Push the boat off the ramp and tie up where the sign says 'No Stopping-Loading Only'. Celebrate the success of the operation and plan the day's fun and frolic in the water.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Oil, Oil Filter and Air Breather - by Curtis Von Fange. In the preceding articles we discussed some of the various aspects of doing a comprehensive tune up. Hopefully some light was shed on why we do or don't do certain things pertaining to inspections and order of events when doing a tune up. Perhaps some useful reasons were given for why parts fail and what to do about preventing part failure in the future. All these tips will help us think and reason out a problem in order to make our tune up last and, hopefully, keep us from spending extra mone
... [Read Article]
Latest Ad:
1 SD Gibson, 1 D Model needs rear end assembled and installed, 1 D Model needs minor repairs, extra parts
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
