Posted by longmeadow farm on December 16, 2017 at 14:13:00 from (24.29.85.217):
In Reply to: Home built log arch posted by Zachary Hoyt on December 16, 2017 at 08:10:34:
Zackary, I applaud you on your willingness and ability to read a "how to weld" manual and get something out of it... to the extent that you are becoming proficient in the use/technology of welding and perhaps becoming a craftsman. It has been my experience that too many people don't take the time to read, study and understand the science/technology behind the activity.. in this case welding. I remember a summer job I had during my college years.. after my 'nam experience. I was working at a summer job as a laborer and a UAW member ..when someone asked if there was any welders in the 'college' guy ranks. I raised my hand and I was given the opportunity. As It was close to quitting time I stalled a bit, grabbed the manual and went home..actually to my summer evening college course. That evening I read the manual as it were.. and the next morning after some attempts that result in total disaster and some creative stalling on my part ...I was off and running. Did I have any welding experience..??? actually no.. but I could read and comprehend..the activity and the science. So I congratulate you on your ability to read and comprehend.. from a retired engineer and now a full time farmer.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
