Posted by Brendon-KS on December 16, 2017 at 05:02:05 from (63.245.145.35):
In Reply to: pto rpm posted by 88-1175 on December 15, 2017 at 21:38:07:
As the others have indicated the implement is designed to run at the same speed regardless of what speed of PTO shaft is driving it. It is common for implements that need a gearbox in the driveline anyway to use one with a 1.35:1 ratio. This provides the same output speed (730-740 rpm) from either 540 or 1000 rpm input speed depending on which direction it is assembled. This minimizes the number of unique parts betweem the two versions and makes for simple field conversion.
You can think of mechanical power, speed, and torque the same as you do electrical power, amps, and voltage. Higher rotational speeds will deliver more power with the same amount of torque just like higher voltage will deliver more electrical power with the same amperage. A 1000 rpm driveline can deliver double (well, almost) the power as the same strength of driveline could at 540 rpm. Somewhere around 80 hp is where it becomes physically impractical to have a driveline heavy enough to withstand the torque of a 540 rpm drive.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Search For Spares - by Anthony West (UK). Following on from the aquisition of the old Fordson F, I was very much in need of spares. As a novice though I didn't appreciate the fact that there were so many Fordson tractors made, that all the other makes seem rare by comparison. As far as I was aware a fordson was a fordson and it was only through trial an
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
