Posted by kcm.MN on December 09, 2017 at 10:09:57 from (174.219.143.181):
In Reply to: Climate change posted by rrman61 on December 08, 2017 at 04:45:38:
[quote="Deutz Lover"](reply to post at 10:32:43 12/09/17)/quote]
Deutz Lover, Beautifully worded!!
I'd like to add one more thing to that. The topic at hand is global sea ice, right? Polar ice caps? Greenland? Just how long have we even been paying attention to the ice volumes? And of that time, how long have we had the capabilities to measure such volumes?
In the past 50 years, there have been solid land masses that have appeared and then disappeared, due simply to the movement of the Earth's crust. A small hump that is normally under the water one day may suddenly be above the water the following week due to seismic events.
Now, add that into what we "know" about global weather (that it's averaged over THOUSANDS OF YEARS(!!) and you can understand why I'm not overly concerned with the amount of ice at the polar caps. Yes, the planet appears to be in the midst of a warming trend, but it's not unlike other warming trends that have happened many times before.
It annoys me when mankind looks at just a tiny fraction of a story and then jumps to conclusions.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
