Posted by Destroked 450 on November 26, 2017 at 23:13:25 from (173.242.142.14):
In Reply to: Repower 1975 F-600 posted by olgentdc on November 26, 2017 at 08:12:17:
Things will get a little tight in that 75 model, engine should fit but theres not a lot of space between the radiator and grill for a inner cooler.
I don't know of any adapters to bolt a Ford FE bell housing to a Cummins engine so your probably looking at getting a trans with SAE bell housing. Don't even think about using a pickup trans in that truck. Rear axle gearing is another issue, 5.9 governors at 2800, you engine probably cruises at 3000- 3200 and governs at 3900.
Your best bet may be to use the engine, auto trans and rear axle from the bus, but it probably has air brakes and your F-600 has hydraulic.
Quick question, are you sure you truck has a 391, normally F-600's came with 330 or 361 engines.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - What Oil Should I Use? - by Francis Robinson. I keep seein this question pop up over and over again in discussion groups all over the web. As with many things there are often several right answers and a few wrong ones. Some purist I'm sure will disagree to no end with what I will tell you but most of us out here in the real world don't really care do we ? Some of them only bring their noses down out of the air long enough to look down them anyway. If you are like me you are only doing this old tractor stuff because you enjoy it. You
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
