Back in the early '90s I bought a rather inexpensive little multi-meter at a local store in Houston. Took it to the wizards at Compaq's Test Engineering Dept and they were pretty amazed at how accurate that little thing was. It led a very useful life of about 25 years before crapping out. Bought an electrical 'set' that stored in a pouch....found out just how crappy the Chinese could make things! I could probably guess more accurately than this thing worked.
Finally had to go online and do a little research for a better one, but money was REAL tight at the time. Ended up getting another Chinese unit, but this one is much better quality than the "pouch pixie" unit! Sadly, it still has its drawbacks. Will probably fork up the money for a decent Fluke in the future, but just not at that point yet.
One thing I'll say is, the top-level engineers that checked out my unit at Compaq said one of the most important things to do with ANY multi-meter is to throw away the leads and buy/build some top-of-the-line leads. I didn't buy separate leads for this multi-meter, so will probably try that before buying a Fluke.
By the way, that "pouch pixie" meter that I hated so much looks amazingly like the same model that Tee got at HF. I hope you have better luck with yours!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
