Posted by JD Seller on November 25, 2017 at 20:02:18 from (208.126.196.24):
In Reply to: Re: The end of CRP posted by David G on November 25, 2017 at 19:28:34:
That is the trouble. They classified too much ground as erodible. I know your ground is way flatter than the majority of what we farm. We have the majority of the erosion controlled. It takes the HUGE rain falls in a short time to top our dams to cause much erosion.
Much of the original erosion calcifications was at the desecration of the county Soil Conservation Agent. I knew they would want to control everything we did if it was calcified as highly erodible. So I made him go by the letter of the slope/soil charts. Most of mine is classified as moderately erodible. In some counties I know the agents pushed the other way and the majority of their FLAT ground is classified as highly erodible. They did it because they got HUGE amounts of Federal money that way.
So in short the erosion classification on farm land is questionable at the best and flat out fraudulent at the worst. Too many people wanting to farm the Government over farming the land.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
