Posted by Chris Holt on November 20, 2017 at 10:29:57 from (184.151.231.13):
I need some assistance with a 3 point issue. I bought this tractor and everything seemed to work fine. I did a complete service including full fluid changes. Everything was clean and spotless inside. I put everything back together then used it for a few days with a rear blade then one morning the 3 point wouldn�t lift. I took the hydraulic assembly all apart and replaced all the o rings even though they looked fine. Verified the screen was clean, took all the valves apart and verified they move nicely. I reassembled the unit and the 3 point shuddered but lifted. I bled the pump and it made no difference. It went up and down just not as smooth as I�d like. Used it for a few days then parked it with the blade up. Over 2 days it crept to the ground. Without touching the control lever I started the tractor and it immediately lifted up. I parked it in the shop and lowered the blade, now it won�t lift again. Any clues where to start?
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Proflie: Farmall Model C - by Staff. In 1948 the first Farmall Model C tractor rolled out of the factory and into the farmer's field. A follow-on to the Model B, it was slihtly larger in size but kept the same 113 CID engine and 4-speed transmission. Other upgrades included adjustable rear tire spacing (with sliding hubs), a frame design similar t
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
