Posted by rusty6 on November 20, 2017 at 06:11:37 from (207.195.86.125):
In Reply to: Hammer Mill Speed posted by rusty6 on November 19, 2017 at 17:23:09:
Quoting Removed, click Modern View to see
No, it is revolutions per minute measured on the hammer mill shaft that the manual specifies. And yes, you can make flour. Interesting that we used to change from the small (3/8 inch) hole screen to grind oats and then use the big 2 inch hole screen to grind hay and straw. In later years I just used the big hole screen for grain. The small hole screen was literally wearing out. We found the big hole screen still did an acceptable job of grinding oats for cattle feed. You don't want it too fine.
Surely you have all seen me at work with my old hammer mill but I'll post the video link again.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Oliver 70 Row Crop - by Staff. The Oliver 70 was part of the "Fleetline Series" and was manufacturered from 1937 to 1948. The row-crop configuration could have either dual or single front wheels. The Oliver 70 was also offered in the standard, orchard and industrial configurations. The tractors were sold in Canada. An early advertisement states "Power when you want it - power when you need it - power to help put in crops when field conditions are right and time and help are limited. That's the power you'll find in an Oliv
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
