I am not making any judgments about what any group of persons is capable of, as that is not something I've studied. What I can comment on is my own experience over quite a few years in actually using lots of parts from all over the world. While I don't doubt there are some lousy workers in some US factories, I have almost always found American made to hold up better than parts from say, China, India, Brazil, etc. Foe example, I got an oil pressure gauge for one of my Molines about a year ago. It was made in India, and filled up with oil in its face within about an hour of being used. I got a gasket set that was made in Mexico, and the holes punched in it were too small for the bolts that had to go through it. I got another heat gauge made in China, and the needle fell off when I was putting it on, and it wasn't like I was being rough with it. I could go on, but you get the idea. The US parts tend to be more expensive, but seem to last better. I do not necessarily blame the workers in the factory, who perhaps know nothing about what the part they are putting together even does. I do suspect there is very little in the way of quality control in many of these foreign factories. I've also noticed that tools made in Asia seem to made of very poor metal, that bends or breaks quite easily compared to US tools. My practice has been to keep my good quality wrenches in my shop, but put the cheap Chinese and Indian wrenches in to tractor toolboxes, as those are much more likely to bounce out and get lost. I would really hate to see that happen to a Snap On or MAC wrench. From what I have read, the workers in many of these foreign factories are very poorly paid, and that probably affects their interest and morale. Also, the workers are not to blame if they are given poor quality materials to work with. Just so it doesn't look like I am totally down on all non-US goods, I will admit I have a car that was made in Korea, that is holding up very well.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
