Posted by rankrank1 on October 22, 2017 at 09:54:49 from (166.137.14.80):
In Reply to: Bad condenser posted by MarkB_MI on October 21, 2017 at 12:11:42:
I keep all my known to be good condensers and I covered that explanation in an earlier post: Most I inherited from my dad when he died as he always saved his old known to be good ones and it is a practice I have continued. I have a gallon bucket full of them. Bad ones get the wire cut from them and tossed so no chance they will ever get re-circulated again by me.
In my dad's era it was common to tune up vehicles with otherwise relatively good points and condensers as preventative maintenance. If the vehicle was running very well when it was tuned up then those were all assumed to be good parts to be saved. Same for tractors.
Additionally I have brand new parts that dad well never got around to getting installed before he died. These are brand new parts but made in the 1970's and not in the land of almost right so having a failure right out of the box is nearly unheard of like the poor quality ones you buy today.
In your case, when the tractor would not run right or at all with all the new parts, then I would have left all the new parts installed and simply put the old condenser back in there (assuming tractor ran great before). If it ran good again well I would know my new condenser was bad.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
