Posted by Kerwin on October 17, 2017 at 10:21:13 from (204.54.36.245):
In Reply to: Corn Crib Question posted by Kerwin on October 16, 2017 at 18:31:25:
Thanks for all of the info. My reason for asking is that I put up a double corn crib with the center alley several years ago for ear corn. My original design on the roof was three hatches down each side above each crib area for filling using an elevator. Unfortunately with the steel roof there is leakage around the top of each hatch (water piles up above the hatch and gets in around the flashing). I'm going to rework the roof to either use three hatches along the roof line or a central cupola setup; still filling using an elevator. I like the looks of the central cupola, but need to figure out a way to route the corn to allow more level filling along the length of the crib...thus my question. Two things are complicating the situation, the rafters I used have cross braces that don't give me a lot of open space above the cribs and one end of the left crib side is a granary for oats...so even if with a central cupola filling each crib side I would still need to be able to get oats to the granary at the end of that crib. Hopefully that description makes sense. Thought about reworking the rafters to get me more room above the cribs for swinging a chute around. Or just putting in a roofline hatch for the oats and use center cupola for corn. That way I wouldn't have to move the elevator during corn harvest. Hindsight is always great...Would have gone with a gambrel hip roof for more upper space but oh well.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
