Posted by Chlln1591 on October 10, 2017 at 08:51:08 from (66.87.125.89):
Hi all first time poster but have referenced this forum several times over the last few years. I am an equipment manager for a golf course and we have run into a small problem, we were offered a great deal on a wiedennman super 500 leaf sucker/brush clearer/verticutter however our two tractors(MF 2135 Turf and a Jacobsen G-20D(rebadged MF 20C) do not have auxillary hydraulics. The 500 uses them(1 input 1 output standard size it looks like) connecting to its own valve block with three levers for tilt door open/close and dump. With some research i see this is something that has been done, but most threads i find on it are long dead with picture links broken. We may sell one and just upgrade if it cannot be done, but if it can i am asking for help of those more knowledgeable in this field than myself. The 3 point does not need to work during operation of the auxillaries.
Is this something that can be done? Or should we sell one and start looking for something with them already onboard?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tuning-Up Your Tractor: Secondary Ignition Wires and Distributor - by Curtis Von Fange. In our last episode we spent the entire day checking out the spark plugs. Is that efficency? Actually, it took more time to explain than it really did to do the inspection. At any rate we decided that a compression test was in order so we could verify the internal engine status. That way we wouldn't buy any tune up parts until we were sure that the engine was in reasonable mechanical condition. Our tests showed a fictional compression reading of 85, 80, 82 and 86 psi. That is well within a
... [Read Article]
Latest Ad:
1958 FORD RARE 4x4 801 TRACTOR, ELENCO/FRONT DRIVE, FRONTLOADER AND WEIGHTED REAR WHEELS, FIVE SPEED, LIVE PTO, GAS ENGINE, NEW REAR WHEELS AND TIRES, ENGINE RUNS.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
