Posted by Brown Swiss on October 05, 2017 at 17:13:34 from (96.61.189.51):
In Reply to: Custom Havest rates posted by Bruce from Can. on October 05, 2017 at 07:16:34:
Ya I paid 430 per cutter head hour for the chopper and 90 per hour for each truck last year, on a positive note they took less fuel then what I would have used which amazed me. This year I am slowly doing it myself and my dad of course. The reason I hired it last year was a noise in the chopping tractor plus the knives in my Massey chopper were cracked and I could not buy new ones. So bought my neighbors 800 Gehl and had to rebuild it, along with narrow the head, wasn't much fun! The only thing so far I have noticed that pays to hire it done is the wrapper, he charges 3 dollars per bale, I supply the plastic, I couldn't buy a wrapper and do my own for that!
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Engine Basics: Spark Plug Cleaning - by Staff. Cleaning procedures: Brush or blow dirt from around the spark plug base. Remove the plug with a correctly fitted wrench. Examine the porcelain insulator and points. If the insulator appears to be melted or blistered, cracked or broken, and the points seem unduly burned it is evident that the plug is operating too hot and it should be replaced with a colder plug. If the plug is fouled excessively with carbon it apparently is operating too cold and it should be replac
... [Read Article]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
