Posted by blais3pascal on September 27, 2017 at 17:54:00 from (75.185.158.42):
Hi all, I have a Ford 1220 compact tractor with front loader and 4WD. It has a little over 500 hours. This is my first tractor and I have gained experience with it over the past couple years slowly clearing a couple acre lot, grading it and removing small stumps. Well you experts probably know that it hasn't gotten the best care since it is a small tractor and probably shouldn't be used to remove stumps, especially dead on with the bucket jamming/forcing the front wheels into the ground. Well with all this dry weather, the ground like a rock, I removed two stumps, then went for the third and bang, it felt and sounded like the front frame of the tractor was slammed with a sledge hammer.
To my surprise I was able to back the tractor up, but quickly noticed that the front wheels were locking up, at least one side. I can't determine if they both lock at the same time. I think only one will drag, then release, then maybe lock again on the next rotation. I slowly got it back to the garage. It does it in both 2WD and 4WD. However when I jacked the whole tractor off the ground, all seems fine. The front wheels disengage in 2WD and engage in 4WD and spin counter to each other. When off and I manually spin the wheels, they feel normal with no crunching, grinding, or jamming. Also with the tractor on and in drive, no jamming, it appears normal. When I put the tractor back on the ground, in forward, reverse, 2WD or 4WD the momentary jamming starts again. Also a small leak has started on the right side of the tractor and I have attached a picture. The amount of fluid in the picture is from the last 24 hours roughly.
I am a novice, have done basic truck maintenance such as ball joints, idler arms, alternators, all easy stuff. I sure would like to try and fix this myself, but am guessing it will be far too complicated for me. I have access to quite a few tools though.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
