If you reread his post, he can't get the pan to even wiggle on the block. He might need to do all you suggest after he gets it loose???
If you're sure you got all the bolts out, take a putty knife and drive that between the pan and block, into the gasket, and start working it around. I would leave a couple of bolts loose on the pan so it won't drop loose and bust you in the head....
In trade school I was tearing down a 350 Chevy engine. Guy had used non-detergent oil for 100K so the sludge was so thick it almost buried the valve springs in the head. We dug thru the sludge looking for the head bolts, got 16? out and the head was still tight. A Cheby fan told us to dig into the sludge in a lower corner and there was another bolt there.
There was. If there is any dirt still on the pan, dig thru it and make sure nothing is under it....
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Antique Tractors a Passing Fad? - by Tractor Talk Forum Participants. A Talk of the Town article - Do you see antique tractors going out like a fad? Value has come down this winter. An example is the Ford Model A and T cars that went through this in years ago, along with the hit & miss engine. Will the younger generation move on to something else? Will it be harder to sell them and what models will be affected? Could we see the value crash on our rusty relics?
... [Read Article]
Latest Ad:
Ford 3-Point Single Bottom Moldboard Plow with Coulter
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.