Posted by bhayden on September 21, 2017 at 19:26:11 from (76.121.189.180):
I know, I should have changed this before it let go :oops:
, on Flickr
FWIW, this is one of the hoses that controls the bucket on an old (circa mid 1960's) Parker backhoe attached to my '61 Fordson Dexta. The hydraulic system is separate from the tractor's and driven by a pump mounted directly to the PTO:
on Flickr
I'm guessing the "plug" in the three o'clock position is the drain? It's likely long past time to drain (flush?) the system and replace the fluid. Any thoughts on what ISO grade I should use; 32, 48, 64? Or is there something specific I should be looking for in the grade/spec/etc.
I figure now is a good time to replace the gauge that died:
on Flickr
Any thoughts on how to bleed the air out of the system or is will this take care of it's self?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.