Posted by JD Seller on September 18, 2017 at 20:10:14 from (208.126.196.24):
In Reply to: 1030 engine woes posted by Jon f mn on September 18, 2017 at 18:40:59:
Check for open internal oil ports. I had a JD 5020 spin the number one main bearing twice, with low hours of use. The ventilator pump was blocked off. What I did not realize was that they had also removed the drive gear and shaft form the housing. This opened an oil port that was in the vertical galley with the number one main bearing. The rear of the motor had good oil pressure but the front oil galley would loose pressure when the oil warmed up. Plugged the port and the tractor is still running 30 year later.
Your losing oil flow/pressure at the crankshaft. I am assuming the engine oil is not breaking down. So for some reason your losing the hydrodynamic bearing on the crankshaft and mains. So with the gauge showing pressure your not getting the same pressure to the lower end of the motor or you have a leak in the lower end.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - It's Alright Where It Is! - by Anthony West. I have a tale of a different kind to tell. Whilst rooting in the hedge bottoms this week I had cause to visit Chapel lane Farm, the home of an eccentric gentleman by the name of Austin Kendall. I had heard rumours that an old Case Model C was languishing away in the back of one of the outbuildings there. So off I went in search of what would turn out to be a very rare and unusual tractor. Mr Kendall is an excitable chap to say the least. He is amongst the last of a dying breed of farmer who
... [Read Article]
Latest Ad:
Wanted to buy model 65 massey ferguson 65 diesel
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
